4x20 LCD with I2C Module

Everyone loves character LCD, is cheap and works out of box! This is 20x4 character LCD module. But the need for 6 to 10 GPIOs is the pain :) It takes most of GPIO of Arduino and other microcontroller. Now with this I2C or Two wires interface LCD, you will save a lot of GPIO for your sensor and motor control.

This is a great blue backlight LCD display. As the pin resources of Arduino controller is limited, your project may be not able to use normal
LCD shield after connected with a certain sensors or SD card. However, with this I2C interface LCD module, you will be able to realize data display via only 2 wires. If you already has I2C devices in your project, you can still program this LCD with the correct I2C address. It is fantastic for Arduino based project.

Note: If the display is not clear (or blank), try to adjust the contrast level by tuning the on-board potentiometer.

Features:

• 4x20 Character LCD
• I2C Address: 0x27
• Backlight (White character on Blue background), enable or disable by a mini jumper at the back of LCD
• Supply voltage: 5V
• Size: 98x60x20 mm
• Come with I2C interface