هذا الموقع هو منصة مختصة بالبحث عن اسعار المنتجات في الاردن, لمساعدتك في البحث عن افضل سعر للمنتجات في السوق. اكتب اسم او رقم المنتج الذي تبحث عنه في مربع البحث بالاعلى واضغط على زر البحث, وسنقوم بإظهار الناتئج المطابقة مرتبة حسب افضل سعر.
CRESTRON USB-EXT-2 -Remote
- حالة التوفر :
- متوفر
- النوع :
- USB-EXT-2-Remote
- الشركة :
- كريسترون
JOD 689.00
The Crestron® USB over Category Cable Extenders, high‑speed USB signal extension for USB 1.1 and 2.0 devices in a conference room, classroom, auditorium, command center, medical facility, public space, or residence. Without requiring any special configuration or drivers, the USB extenders enable wire runs up to 330 ft (100 m) over a single CAT5e (or better) unshielded twisted-pair (UTP) cable. The USB extenders support most USB device types and are plug‑and‑play compatible with computers running Windows®, macOS®, and Linux® operating systems.
Linking the two extenders requires one run of CAT5e unshielded twisted-pair cable.2 Both extenders are powered by a single 100-240 VAC power supply, which can be connected at either end to an AC power receptacle.3 The USB‑EXT‑2‑LOCAL and USB‑EXT‑2‑REMOTE are compatible with the USB over Category Cable Extender Wall Plates
Key Features
- Provide reliable, high-speed USB signal extension for most USB 1.1 or 2.0 devices1
- Compatible with Crestron® USB over Category Cable Extender Wall Plates (USB‑EXT‑2‑LOCAL‑1G and USB‑EXT‑2‑REMOTE‑1G)
- Extend USB signals up to 330 ft (100 m) over CAT5e (or better) twisted-pair cable2
- 100-240 VAC power supply (included)
- Enable transparent point-to-point USB extension without any configuration or programming
- Plug-and-play compatible with most types of USB 1.1 and 2.0 devices and hosts1
- No drivers required with Windows®, macOS®, or Linux® operating systems1
- Transport USB over CAT5e at speeds up to 480 Mbps
- Mass Storage Acceleration maximizes USB 2.0 bulk transfer speeds
- Expandable using up to 4 USB hubs (not included)
- USB‑EXT‑2-REMOTE provides 2 USB Type A ports
- The USB extender is engineered to deliver maximum compatibility with the widest possible range of devices. Crestron does not guarantee that all USB devices or hosts are compatible with the USB extender. Certain USB devices may require additional driver installation if not directly supported by the computer’s operating system.
- For the Link connection between the Local and Remote extenders, as a minimum, use high quality, solid core CAT5e (or better) unshielded twisted pair (UTP) cable. If connecting either extender through a wall jack, a stranded patch cord may be used. The maximum aggregate cable length is 330 ft (100 m) between units. The minimum cable length is 6 ft (1.8 m). Do not connect the Link ports to an Ethernet LAN or any other network or device, including the USB‑EXT‑DM‑REMOTE, USB‑EXT‑DM‑LOCAL, USB‑NX2‑REMOTE‑1G, USB‑NX2‑LOCAL‑1G.
- The power supply must be connected to either the Local or Remote extender, not both. Power is passed to the secondary extender via the Link connection.
| Communications | |
|---|---|
| USB Device Support | USB 1.0/1.1 and 2.0 compatible including mass storage and isochronous devices[1] *Maximum USB Devices 30 USB devices or 4 USB hubs with 26 USB devices |
| USB Hub Support | Any signal chain may include up to 4 USB hubs plus one USB-EXT-2-LOCAL and one USB-EXT-2-REMOTE[1] |
| USB Throughput | USB 2.0 up to 480 Mbps USB 1.1 up to 12 Mbps |
| Connectors | |
| Remote Extender | 24V 1A :(1) 2.1 x 5.5 mm DC power connector; 24 Volt DC power input (power pack included) [3] ___________ Link (1) : 8-pin RJ45 connector female; Connects to Link port on the Local Extender [1] ___________ Config (front) : (For factory use only) ___________ USB (front) : (2) USB Type A connectors female; USB 2.0 host ports for connection of USB mice/ keyboards/ whiteboards/ game controllers/ cameras/audio devices/ mobile devices/printers/ flash drives/ hard drives/ hubs/ and other USB devices [2]; Available USB Power: 1 Amp maximum per port 1.5 Amps maximum total |
| Indicators | |
| Remote Extender | Power (1) Blue LED indicates operating power is supplied via the local power pack or via the Link connection [3] Link (1) Green LED indicates a valid Link connection to the Local Extender Host (1) Green LED indicates a valid connection to the USB host at the Local Extender Activity (1) Amber LED indicates data activity on the Link interface Mode (rear) (1) Recessed pushbutton (for factory use only) |
| Connectivity | |
| Connectivity, standard | USB extension up to 100 m (330 ft) over solid-core CAT5e (or better) unshielded twisted pair (UTP) cable[2] |
| Product Specifications | |
| Power | Available USB Power Supplies 1 A maximum per each of two USB Type A ports 1.5 A maximum total USB‑EXT‑2‑LOCAL USB powered via the USB host interface3 USB‑EXT‑2-REMOTE Input: 100-240 VAC 50/60 Hz; Output: 1 A @ 24 VDC |
| General Features | |
| Dimensions | Height : 1.03 in (26 mm) without feet Width : 2.96 in (75 mm) Depth : 3.43 in (87 mm) |
| After Sales Service | |
| Warranty | 1-year limited warranty |
| FootNote | |
| Notes* | [1]The USB extender is engineered to deliver maximum compatibility with the widest possible range of devices. Crestron does not guarantee that all USB devices or hosts are compatible with the USB extender. Certain USB devices may require additional driver installation if not directly supported by the computer’s operating system. [2]For the Link connection between the Local and Remote extenders as a minimum use high quality solid core CAT5e (or better) unshielded twisted pair (UTP) cable. If connecting either extender through a wall jack a stranded patch cord may be used. The maximum aggregate cable length is 330 ft (100 m) between units. The minimum cable length is 6 ft (1.8 m). Do not connect the Link ports to an Ethernet LAN or any other network or device including the USB‑EXT‑DM‑REMOTE USB‑EXT‑DM‑LOCAL USB‑NX2‑REMOTE‑1G USB‑NX2‑LOCAL‑1G. [3]The power supply must be connected to either the Local or Remote extender not both. Power is passed to the secondary extender via the Link connection. |