هذا الموقع هو منصة مختصة بالبحث عن اسعار المنتجات في الاردن, لمساعدتك في البحث عن افضل سعر للمنتجات في السوق. اكتب اسم او رقم المنتج الذي تبحث عنه في مربع البحث بالاعلى واضغط على زر البحث, وسنقوم بإظهار الناتئج المطابقة مرتبة حسب افضل سعر. 

  • QTA 201 PLASTIC 20KG RED

QTA 201 PLASTIC 20KG RED

حالة التوفر :
Out Of Stock
النوع :
02021-15-510-220
الشركة :
القدس
JOD 17.00
ميجا هارد وير
Update Last Updated: 2024-11-03 04:13:46
Buy Now
Compare this Product
Not yet rated Write a review

مواصفات المنتج

General description:

Special cement-base tile adhesive (copolymer powder of vinyl acetate and ethylene) of high quality. Use mainly for heavy tiles adhesion such as natural stone & marble. Also used for polystyrene board. Meets European standards: EN 12004/C2, EN 12004/C2T, EN 12004/C2E, EN 12004/C2ET.

Special Features:
  • High adhesion strength exceeds 1 N/mm².
  • Withstands high pressure, hence used for adhering heavy tiles.
  • Excellent adhesion despite variation in temp.span (-5 to +60 °C). Also, product performance is resistant to shrinkage and expansion due to change of temperature and humid conditions.
  • Special "extended open time" features that enhances strength of adhesion.
  • High flexibility properties that makes product performance resistant to shocks.
  • Waterproof

Mixing:
  • Put clean water (without chemical additives) in clean mixing container
  • Mix at a ratio of ± 4 kg powder to ± 1 liter of water.
  • Stir by a hand agitator the admixture well for 30 seconds.
  • Make sure that everything is mixed
  • Use an electrical agitator to mix for 1 minute the admixture.
  • Wait for a 5 minutes period (settle-down) before application.

Preparation of surface:

  • Clean all foreign matter
  • Surface & tile must be moistened with water before applying the mixture, especially old surfaces.

 

Application:
  • Apply a layer of the admixture to the prepared surface using any trowel.
  • Use a notched trowel to spread the admixture layer to create air escape spaces.
  • Use plastic spacers based on desired joint width.
  • Place tile and push in.